Advantix rainwater drain
for pipeline connections from DN 50–100
Year built (from): | 01.01.2008. |
Trade mark rights exist for this document; for further information, go to viega.com/legal .
The information in this instruction manual is directed at the following groups of people:
Heating and sanitary professionals and trained personnel
Consumers
Individuals without the abovementioned training or qualification are not permitted to mount, install and, if required, maintain this product. This restriction does not extend to possible operating instructions.
The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use.
Warning and advisory texts are set aside from the remainder of the text and are labelled with the relevant pictographs.
This symbol warns of possible life-threatening injury.
This symbol warns of possible serious injury.
This symbol warns of possible injury.
This symbol warns of possible damage to property.
This symbol gives additional information and hints.
This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e.g. EN) and/or in Germany (e.g. DIN/DVGW).
Some passages in the text may refer to technical codes in Europe/Germany. These should serve as recommendations in the absence of corresponding national regulations. The relevant national laws, standards, regulations, directives and other technical provisions take priority over the German/European directives specified in this manual: The information herein is not binding for other countries and regions; as said above, they should be understood as a recommendation.
The following standards and regulations apply to Germany / Europe and are provided as a support feature.
Scope / Notice | Regulations applicable in Germany |
---|---|
Rainwater | DIN 1886‑100 |
The Advantix rain hopper is intended for discharging rainwater from the roof drain.
The Advantix rain hopper is intended for draining of rainwater in constant operation, see Regulations from section: Media .
It is not permitted to introduce wastewater which would damage the product material.
The drainage capacity is 6 l/s.
Nominal width [DN] (drain socket) Nennweite [DN]Ablaufstutzen | 100 |
Drainage capacity | |
Dimensions and installation height |
The rain hopper can be installed parallel with or at an angle of 90° to the wall.
Before assembly:
Check if the drainage capacity is sufficient for the arising water volume Drainage capacity .
Ensure that the required connection line is installed with the necessary incline to the planned installation location.
During assembly:
Observe installation dimensions.
After assembly:
The drain casing must be fully lined.
Requirements:
A pipe to the planned drainage position is already in place for the connection to the wastewater system.
The drainpipe has an internal sealing lip.
Measure the diameter of the downpipe.
Cut the pipe lead-in according to the diameter of the downpipe.
Place the rain hopper in the floor and connect the wastewater pipe.
Mount the rain hopper level with the surrounding surface and secure against sinking.
To maintain a consistent drainage capacity, the leaf trap must be emptied regularly.
Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements.